BELLTECH - SHACKLE AND HANGER KITS

Select Vehicle

Priced from:

$53.60 - $321.40
Product #: 69709G Brand: BellTech
Customer Rating: 4.3 of 5 stars
BELLTECH – SHACKLE AND HANGER KITS
  • Drops vehicle up to 5.0” (depending on application)
  • For lowering vehicles equipped with leaf springs
  • Repositions leaf spring mounting points
  • Retains leaf spring and the vehicle’s factory load capacity
  • Retains smooth factory ride
  • Custom fit by year, make and model
  • Limited lifetime warranty

If you want to balance out your suspension and lower your center of gravity in your leaf spring equipped vehicle, a Belltech shackle and hanger kit will get you up to 5 inches lower for a smooth ride and aggressive stance. Belltech is a recognized leader in aftermarket lowering suspension systems for trucks and SUVs, and its specialty lowering products touched off the custom sport truck craze in America.

See kit for contents, application and installation information.



Overall Rating
4.3 out of 5
4.3 out of 5
Open Ratings Snapshot
Rating breakdown 3 reviews
5 Stars
2
4 Stars
0
3 Stars
1
2 Stars
0
1 Star
0
3 of 3(100%)reviewers would recommend this product to a friend.
Product ReviewsWrite a review
Overall Rating
5 out of 5
5 out of 5
Easy and inexpensive
August 16, 2013
BryanR
Location: Madison, AL
How often do you shop at JC Whitney.com? First Time
"All you need are jackstands, a jack, and a few tools. One hint I can give....if you have the tow hitch installed, you don't have to remove it. We just cut out the small tab in the way of the bottom bolt. I see no issues with doing so."
Pros: Everything
Cons: None
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
3 out of 5
3 out of 5
Good product
May 14, 2013
ALMarkR
Location: Huntsville, AL
How often do you shop at JC Whitney.com? Multiple Times a Year
"Overall a good product. Kit dropped the rear end of a 92 Chevy Silverado about 2 inches. Was looking for 3 inches. Once we put the pickup bed back on, noticed that the rear clamp on the leaf spring would hit the cross brace on the bed when bouncing on the bed. I'll have that cut out for clearance.
One thing that was a pain in the butt is the curve metal housing on the front leaf spring mount where the front mount coil is, is very close tolerance. So close I had to file the spring thru bolt hole oblong to get the bolt to go thru. The rubber bushing is too tough to allow it flexibility to go through with existing dimensions and the spring coil around the bushing hits the curved mount area."
Pros: Gave a two inch drop, not too hard to install
Cons: Had to file out a hole to get spring thru bolt to get through and spring clamps hit bed.
+2points
2out of 2found this review helpful.
Was this helpful?helpful2unhelpful0
Overall Rating
5 out of 5
5 out of 5
supreme quility
April 24, 2013
hotrodhillbilly
How often do you shop at JC Whitney.com? Multiple Times a Year
"nice product. gave my truck the stance i was looking for. two holes for 1 inch or two inch drop"
Pros: powder coated and looked good
Cons: they didn't install themselves
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0