RUGGED RIDGE - ROLL BAR MOUNT REAR SIDE GRAB HANDLES

Select Vehicle

Priced from:

$15.60 - $18.40
Product #: 26273G Brand: Rugged Ridge
Customer Rating: 4.8 of 5 stars
Features
RUGGED RIDGE - ROLL BAR MOUNT REAR SIDE GRAB HANDLES
  • Keeps you from bouncing around during off-road adventures
  • Makes it easier to enter and exit your Jeep
Rugged Ridge's roll bar mounted rear side grab handles easily install in factory mounting holes using original hardware. Choice of red or black webbing with molded handle. Rugged Ridge manufactures high quality parts and accessories for Jeeps, trucks and off-road vehicles and is internationally recognized as a market leader when it comes to floor liners, snorkels and modular bumpers in particular.

Overall Rating
4.8 out of 5
4.8 out of 5
Open Ratings Snapshot
Rating breakdown 4 reviews
5 Stars
3
4 Stars
1
3 Stars
0
2 Stars
0
1 Star
0
Ease of Use/Installation
4 out of 5
Quality/Construction
4.5 out of 5
4 of 4(100%)reviewers would recommend this product to a friend.
Product ReviewsWrite a review
Overall Rating
5 out of 5
5 out of 5
worked as advertised
April 17, 2014
Anonymous
Ease of Use/Installation
3 out of 5
3 out of 5
Quality/Construction
4 out of 5
4 out of 5
" Followed the advise of past customer comments. Installed smoothly. I did not drop bolts or washers. I used a needle nose pliers to remove after loosening with ratchet. Then installed with electrical tape so bolt would not drop on install. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
4 out of 5
4 out of 5
Handy Handle
December 7, 2013
Linton
Location: Arizona, USA
How often do you shop at JC Whitney.com? Multiple Times a Year
Ease of Use/Installation
4 out of 5
4 out of 5
Quality/Construction
4 out of 5
4 out of 5
" I installed the handles for the front seat riders, between the windshield and "A" pillar. They are used to assist myself and other disabled persons to enter the Jeep. The bolt in the "A" pillar is not easy to loosen. A hand wrench won't work. I used a ratchet with a long socket, but a socket extension would work too. Bolt torque setting instructions would be a nice addition. Follow the installation directions carefully to avoid dropping a washer or bolt down the "A" pillar cover, but if you do drop something, the cover snaps out. You should finish the job in less than an hour. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
5 out of 5
5 out of 5
Grab bar windshield installation advice
November 22, 2013
Lint
Location: Lake Havasu, United States
How often do you shop at JC Whitney.com? Multiple Times a Year
Ease of Use/Installation
4 out of 5
4 out of 5
Quality/Construction
5 out of 5
5 out of 5
" At least one pillar bolt will drop down inside the plastic cover for the front pillar. The covers are held in place with the pillar bolt, one screw and two clips. Remove the bolt and screw, and the covers can be tugged off without damaging them. Re-installation of the pillar bolt was difficult, as the grommet fits OK, but the fabric is stiff and does not fit as well. The original bolt was too short to start the installation. I used a longer, 2-inch bolt to start the installation. After driving the grommet into the access hole, I switched back to the original bolt to finish the installation. Looks great and works. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
5 out of 5
5 out of 5
Great Product
September 29, 2013
Adam
Location: Smith Mountain Lake, Virginia, USA
How often do you shop at JC Whitney.com? First Time
Ease of Use/Installation
5 out of 5
5 out of 5
Quality/Construction
5 out of 5
5 out of 5
" Very easy to install and very well made, They also mount in the corner of your windshield with the same ease. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
RAMPAGE EXTREME SPORT GRAB HANDLES Priced from: $13.99 Set of 2
SMITTYBILT GRAB HANDLES FOR JEEPS Priced from: $8.99 SET
HIGHLAND STAINLESS STEEL GRAB HANDLE Priced from: $34.44 Set of 2
RUGGED RIDGE FIRE EXTINGUISHER HOLDERS Priced from: $23.23 Sold Individually
SKYJACKER UNIVERSAL GRAB HANDLES Priced from: $37.79 Set of 2
CROWN AUTOMOTIVE JEEP GRAB HANDLES Priced from: $22.87 SET
RAMPAGE OE REPLACEMENT ROLL BAR PADDING Priced from: $19.99 SET