Select Your Vehicle

Select by Brand

Get Email Exclusives

Sign up for email updates on the latest exclusive offers

Motorcycle Belt drive Kit

 Shop Motorcycle Belt drive Kit

If the belt drive of your motorcycle is broken, your bike simply won't run.it's as simple as that. You see, this thick, black rubber belt, which runs from the right side of your bike's engine to the rear wheel sprocket, is actually the one in charge of transferring power from the engine to the rear wheels. In short, this component propels your motorcycle to run. If it gets busted, your bike won't be able to move forward. To prevent this from happening to you, the best thing that you can do would be to buy a fitting motorcycle belt drive kit for your repairs. To find out more about this component, keep reading below.

How to Change a Motorcycle Belt Drive

After some time, a motorcycle's belt drive can eventually succumb to wear and tear. And if worse comes to worst, you'll need to replace it ASAP. When this happens, make sure you get the right motorcycle belt drive kit for easy installation. Here's a general guide on how to replace a belt drive.

Step 1: Begin by using a motorcycle jack to raise the rear side of your bike. After that, locate the axle bolt of the rear tire, which is usually at the center of the wheel frame.

Step 2: Once you've located it, remove the axle by using a wrench and pliers to remove the nut that's securing it in place.

Step 3: Next, push the rear wheel towards the engine to be able to slide the belt drive out of the rear wheel sprocket. After that, completely remove the rear wheel and set it aside.

Step 4: Remove the covering of the belt drive by using an Allen wrench to loosen its mounting screws. After that, slide the belt drive from the engine sprocket.

Step 5: When you're done, reinstall the rear wheel by pushing it towards the engine. Then, get the belt from the motorcycle belt drive kit that you purchased and then slide it into the rear wheel sprocket. After that, pull the rear wheel away from the engine and then reinstall the axle and its bolt back in place.

Step 6: To secure everything in place, adjust the belt by tightening it according to the recommended tension levels. If you find that the new component does not fit, you might want to recheck the motorcycle belt drive kit that you purchased if it's a direct fit.

How to Fix a Motorcycle Belt Drive

The belt drive might malfunction from time to time and this may be accompanied by an annoying sound. When this happens, you should adjust it to fix the noise.

Step 1: Begin by locating a spot in the belt drive where tension is at its highest.

Step 2: Next, use the spot as a guide and rotate the rear wheel so that the belt is positioned between the front and rear sprockets.

Step 3: Using the correct tension specifications, adjust the belt until necessary. If the belt still malfunctions after adjustment, you may want to consider getting a new motorcycle belt drive kit for a replacement job.