Driving is all about control.if you have full control over your ride, you'll be able to maximize your vehicle's potential. To achieve this, you need to have functional components that will help you while you drive. Take for instance the window regulator.this component may be hidden behind the door panel, but it actually makes your daily driving easy and convenient. It enables you to open or close your windows fast and with ease. If you think you have a broken regulator in your ride, here are some things that you should know:
Things to Consider When Buying a Window Regulator
- Manual - A manual regulator uses gears and interlocking parts to open or close the car windows. It usually uses a knob for controls.
- Automatic - Compared to manual types, automatic regulators usually come with a switch that is easy to operate. A single push or pull activates the electrical mechanism that raises and lowers the car windows.
If done by a mechanic, getting your car's broken window regulator fixed can cost you more or less $300. However, if you're going to do the replacement yourself, you only need to spend around $100 to buy a new part.
Simple Steps to Fixing a Broken Window Regulator
This is a general guide for installing and removing window regulators. Depending on the vehicle that you drive, some of the steps below may not be applicable.
Step 1: To access the regulator, you need to remove the interior trim of the door panel. Do this by carefully prying out the trim, rubber cover of the door handle, door handle bezel, and switch bezel. Once you've taken these parts out, unplug the switch connectors, disconnect the door lock cable, and remove the door handle.
Step 2: Next, support the door panel and carefully remove it, making sure that you don't damage the wiring harness. After that, take out the door handle bracket and set all these parts aside.
Step 3: If your door panels are equipped with a vapor barrier, peel it off using a putty knife. Make sure the barrier does not get in contact with cloth because the sealant it contains is hard to remove.
Step 4: Before cutting the window regulator cable to move the window glass into position, make sure you support the glass to avoid breaking it. Once you've cut it, move the glass to access the mounting bolts of the regulator.
Step 5: Fully close your window and tape the glass using painter's tape to avoid causing damage to the door. Then, remove the window lift motor connector and the bolts that hold the regulator to remove the part completely.
Step 6: Once you've taken the old regulator out, install the new one by positioning it and bolting it in place.
Step 7: Reattach the lift motor plug and window switch before removing the tape from the window glass. Next, align the glass onto the regulator and lubricate the window run using silicone spray or grease.
Step 8: Test if the window regulator is installed correctly, making sure the glass moves up and down smoothly.
Step 9: Close the window, reinstall the vapor barrier, door handle cable, wirings, rubber grommet, door handle bracket, door panel, door lock cable, and all the other components that you took out earlier.