When it comes to car maintenance, knowing how to change your tires is one of the most practical and essential skills you can have. Whether you’re swapping out winter tires for summer ones or handling an unexpected flat, the process is straightforward with a little preparation. This guide will walk you through it step by step, ensuring you’re ready for any tire-changing scenario.

Preparing Your Car for a Tire Change

Before you dive into the process, safety is key. Start by applying the handbrake to prevent the car from rolling. For added security, place a heavy object—like a rock or wheel chock—behind the tires opposite to the one you’re changing.

Once your car is secure, position your hydraulic jack (or any jack provided with your vehicle) beneath the car. The jack point is usually located near the wheel well, often indicated by a notch or reinforced area. Pump the jack until the tire lifts about five to six centimeters off the ground, providing enough clearance for removal.

Removing the Old Tire

Using a lug wrench or an impact gun (if you have one), loosen the screws on the wheel. An impact gun will save you time and effort, but a standard wrench works just as well with a bit of elbow grease.

With the screws removed, pull the old tire off the hub. This is the perfect opportunity to inspect the wheel and hub for any damage or debris before installing the new tire.

Installing the New Tire

Position the new tire on the hub, ensuring the screw holes align properly. This might feel tricky at first, but applying gentle pressure with your leg to hold the tire steady can help. Start threading the screws by hand, tightening them as much as possible before using a tool.

To secure the tire evenly, tighten the screws in a crisscross pattern. For example, if you start with the top screw, move to the bottom, then to the right, and finally to the left. Tighten each screw lightly on the first pass, then repeat the pattern to secure them more firmly. Avoid over-tightening, as this can damage the threads.

Ensuring a Secure Fit

After all screws are tightened, lower the car back to the ground using the jack. Test each screw by hand to confirm they’re secure but not overly tight. A snug fit is all you need—there’s no need to put your entire body weight into it.

Checking Tire Pressure

Proper tire pressure is essential for safety and performance. Locate the PSI rating on the sidewall of your tire, then use an air compressor to fill the tire to the recommended level. For example, if your tire specifies 44 PSI, inflate it accordingly and double-check the reading with a pressure gauge.

Repeat for All Tires

Follow these steps for each tire, ensuring consistency and safety across the board. After completing the change, take a short drive and double-check the screws’ tightness and tire pressure to confirm everything is secure.

Changing your tires doesn’t have to be intimidating. With a little practice, you’ll feel confident tackling this task whenever needed.

For more DIY tutorials and car maintenance tips, visit Tech & Design’s YouTube Channel. You can also connect with us on Twitch.

About Tech & Design

Tech & Design Productions brings you unbiased reviews and ratings for tech products, along with specs, most up to date technology news, tutorials, how to videos, gaming, prices and more.