The other day, I was out harvesting firewood when fate—or rather, a rogue stick—decided to mess with my truck. The stick jumped up off the ground and wedged itself into the shifter mechanism under my 2018 Chevy Silverado. The result? My truck wouldn’t shift into park.
With the shifter pushed all the way up, the gear only reached neutral. Stuck in this limbo, I set up a blanket, lights, and my tools to dive under the truck and figure out what went wrong. Here’s how I uncovered the problem and replaced the lower shifter cable to get my truck back in working order.
Identifying the Problem
Underneath the truck, I traced the drivetrain from the engine, through the transmission, transfer case, driveshaft, and rear differential. The transfer case connects the front driveshaft to the front differential when engaging four-wheel drive. But my focus was on the side of the transmission, where the shifter arm connects via a cable to the shift lever on the steering column.
Sure enough, the stick had wedged itself right into the mechanism, bending the shifter cable. You could even see the rub marks left by the shaft on the stick. The cable was bent at an awkward angle and no longer working as it should.

Removing the Old Cable
The first step was to remove the bent cable. I started by popping it off the shifter arm with a screwdriver. Then, I used pliers to loosen a broken clip that held the cable in place. (Pro tip: If all your clips are intact, you’ll need to squeeze both locking tabs to release the cable.)
Before pulling the cable out completely, I snapped a picture to document the routing for reassembly. The cable snaked from the transmission, over the frame, and up to the steering column. Once removed, I inspected the damage. The rod inside was visibly bent, and the rubber boot was torn—confirming that this cable needed to be replaced, not repaired.

Installing the New Cable
I picked up a new shifter cable from the dealership for $60. Tempting as it was to bend the old one back into shape, the damage to the rod and boot made replacement the safer option. Here’s how I installed the new cable:
- Routing the Cable – I followed the same path as the old cable, threading it from the steering column, over the frame, and down to the transmission.
- Securing the Cable – The bracket on the transmission had a tab and hole that needed to align perfectly. A firm pull popped the cable into place.
- Reassembling Components – I reattached the clips, ensuring they were secure. The plastic clip that had given me grief during removal was popped back on, and I compressed the spring before locking it in.
Moment of Truth
With everything reassembled, I tested the shifter. Finally, I could shift into reverse and park again! No more being stuck in neutral or worrying about being stranded.

A Quick Fix with Big Results
This repair cost $60 and about an hour of my time, but it saved me from potential headaches down the road. If your shifter cable ever takes a hit—whether from a stick, rock, or some other rogue object—don’t hesitate to tackle the repair yourself.
For more DIY repairs and helpful automotive tips, visit my YouTube channel, How to Build, Fix, and Have Fun! at youtube.com/@HowToLou. Thanks for reading, and as always, happy wrenching!