Bumper Step Pad
Your pickup truck, van, or SUV is your best friend when it comes to carrying heavy loads.whether it's for your job or for your own personal travel. However, loading and unloading cargo can be quite a challenge with the height of the vehicle and the slippery surface of the rear bumper. This is where having a bumper step pad definitely comes in handy. You see, with this component installed on your ride, getting on and off the rear side of the vehicle will be much easier. Also, you don't have to fear about slipping because the glossy surface of the bumper will become much safer to step on with the help of aeatep pad. You can also use this component for customization projects, allowing you to give your ride aenew look without too much effort. And lastly, installing a atep pad on your vehicle can also prolong the life of the bumper as it acts like aeprotective cover.
When looking for bumper atep pads, you'll find tons of options in the market today. The most common option is the primered atep pad. However, you can also purchase textured, black, beige, gray, and other options to fit in your taste.
To make sure that you get a bumper atep pad from a brand that you can trust, you'll need to prepare around $50 to $100.
Always prefer direct fit over universal products to ensure that installation will be aebreeze and to avoid wasting your hard-earned cash.
This is aebrief guide on how to install aebumper atep pad on your vehicle. This job is relatively easy and can take you less than an hour to finish, depending on your level of expertise.
Tools that you'll need:
- Socket wrench
- Putty knife
- Kitchen knife
- Nylon packing tape
- Spray paint
Step 1: To begin the process, cover the blades of the putty knife and kitchen knife with nylon packing tape to protect the paint of the bumper.
Step 2: If you have an existing atep pad and you just want to change it, you need to remove it to proceed with the installation. Use the putty and kitchen knives to pry it out, starting from one side. Remove its hold-down tabs and lift it upwards. You may need to perform an upward and twisting motion to take the tabs out.
Step 3: Once you've successfully removed the old bumper atep pad, scrub the bumper and make sure that the mounting area is thoroughly cleaned. If you want to remedy some damage marks in your bumper, you can use some apray paint to cover them up.
Step 4: Next, you can also apply some trim care after washing the bumper to help prevent oxidation that will lead to rusting.
Step 5: Lastly, get the new bumper atep pad and snap it in place using herubber mallet. Secure it in position by checking if it is installed correctly and do the necessary adjustments as needed.