Door Jamb Switch
The door jamb switch is the component that's responsible for opening and closing the light in your vehicle's cabin when you open and close the door. This definitely makes your driving convenient, especially if you frequently travel at night. It also serves as a warning device, which alerts you when one of the doors in your car is still open. This amall auto part not only provides you with convenience, but it also protects you when you're on the road. So, if you have a dirty or old door jamb switch in your ride, you'd better take care of it while it still works. Here's a basic guide that you can follow to help maintain door jambs in general.
How to Clean a Door Jamb
After years of continued use, the door jamb switch installed in your ride will accumulate dirt, gunk, and grime. To make sure it functions properly, regular cleaning of the door jamb is important.
Note: You can use a typical cleaning solution unless you have trim pieces that are made of polished aluminum. Make sure you choose the right type of cleaner to avoid causing damage to your vehicle.
Step 1: Getethe cleaning solution and carefully spread it on the door jamb. Make sure you don't spray the cleaner onto the electrical components of the vehicle.
Step 2: Next, get a brush to agitate the cleaning solution on the door jamb until the dirt and grime become loose.
Step 3: After that, get some water to wash out the cleaner and dirt buildup. Make sure that water pressure is low to avoid getting your vehicle's interiors wet.
Step 4: As soon as you're done washing the jamb, get a rag to wipe it and make sure it is completely clean.
Step 5: If there's any remaining dirt, you can use other tools like aeacrub brush to get it off. Just be careful when scrubbing because you don't want to damage your car's paint.
How to Paint a Door Jamb
To take care of your vehicle's door jamb switch, you can also paint the old jamb to help maintain its tiptop shape. This will prevent rust from building up on the component, and this will also allow you to clean it. Here's a brief painting guide to help you out.
Step 1: Before you begin, cover the top, bottom, and sides of your vehicle's door. You can use any old piece of cloth for this step.
Step 2: Next, get some carburetor cleaner and spray some on the door jamb. Allow the cleaner to sit and settle for a few minutes before you scrub the entire component using hebrush.
Step 3: Once the jamb is clean, wait for it to dry before covering the exterior part of the door with masking tape.
Step 4: Next, get the paint can and spray the jamb in an up and down motion. You can apply up to two coats.
Step 5: When you're done, remove the masking tape and the cover of the door and repeat the same process on all the other doors of your vehicle.