Select Your Vehicle

Select by Brand

SHOP BY PHONE
1.866.529.5530

Get Email Exclusives

Sign up for email updates on the latest exclusive offers

Air Suspension Compressor

 Shop Air Suspension Compressor

When it comes to your ride, you want nothing but the best. So you're not afraid of doing some upgrades here and there. In fact, you've even invested on a new air suspension system, which makes your vehicle easy to adjust. You can have a firm ride today and a soft ride the next. It also improves the balance of your ride, which makes your overall driving experience exceptionally pleasing. Unfortunately, your new suspension system would be useless if you have a faulty air suspension compressor. This component is something that you simply can't do without because it's actually the one that's responsible for supplying air to the suspension's air springs. And without air, your new suspension won't work as it should. So, before your whole system goes down to the drain, replace that faulty part right away. Here's a ten-step guide on air suspension compressor removal and installation to help you out.

Step 1: To begin, make sure the suspension switch is turned off. After that, locate your vehicle's old compressor, which is usually attached on the driver's side of the vehicle right under the hood.

Step 2: Once you've located the air suspension compressor, disconnect it to your system by loosening the clamp of the air tube and removing its housing.

Step 3: You also need to remove the screws of the washer reservoir and disconnect the water line. After that, you also need to disconnect the electrical connector and reservoir, making sure that the washer fluid will not leak.

Step 4: Before doing the next step, double check if the suspension switch is turned off and the rear air springs have no leaks of any kind. This is to ensure that the rear end of your ride will not sink once you remove the air line.

Step 5: Next, you need to remove the air line from the dryer by pushing the collar in with one hand and then pulling the line out of the dryer with the other. During this process, your system will most probably let some line pressure out, which is basically a small burst of air.

Step 6: After that, remove the pin connectors and the nuts at the bottom of the air suspension compressor. At this point, you should already be able to take the compressor out with ease.

Step 7: Next, mount the new compressor on the vehicle and make sure that everything is perfectly aligned. Once you're happy about its position, connect the nuts at the bottom to hold it in place.

Step 8: Reconnect the electrical pin connectors that you took out earlier and reinstall the air line into the hole of the dryer. You should also put the plastic cover of the compressor compartment back in place.

Step 9: Next, connect the water line and the wires of the washer reservoir before reinstalling the washer reservoir itself.

Step 10: After that, mount the filter housing back by clamping it to the air tube. Lastly, test your vehicle to see if your new air suspension compressor works fine.