Great when backing up or to illuminate a large area behind your vehicle for work or play
Black UV-resistant, high-impact, injection-molded ABS plastic housing
Mounts in Class III, IV or V 2" receiver tube. Opening in the center of the light housing allows use of the receiver without removing the light system. Provides exceptional rear lighting when towing. Requires 3/4" clearance between top of receiver tube and bottom of bumper. Incorporates 2 halogen lights, each slightly angled to the sides to illuminate an extra-wide area. Easy to install. Only 3 wires to hook up to 12-volt power source ground and back-up light wire. Lights go on automatically when you shift into reverse. Or flip the switch to brighten up a work area or campsite — even with the engine turned off. Removes easily. Wiring harness (included) features quickly-connect connectors. Instructions included. Approximately 15"W x 4"H x 4"D. If your vehicle has a factory receiver, you will need installation kit (sold separately).
Cons: Sits even with the lowest part of the trailer hitch; offroad lifespan???
"This back up and utility light system went on my 2011 Nissan Titan equipped with the factory hitch with only a little fuss. I got the seven pin plug accessory and the installation kit as well as the light and was glad I did. Those parts made the installation very easy. A little jiggling was required to get the hitch pin through the receiver and tow hook that I keep in the 2" receiver hitch. The locking hitch pin I have has a fairly large diameter lock on the end of the pin. That required the light to be mounted a little farther to the rear than I started with. The provided spacer that is used to level the light base with the thickened rim of the receiver was too thick; I sustituted a piece of 1/8" aluminum strap as a spacer to get everything to line up right. The wiring was all taken care of by the seven pin adapter and will let you plug in your seven pin trailer lead while the light is still operable. The installation kit was composed of a plate and bolts to relocate the factory seven pin plug. The instructions for installing the plate were great! You do have to drill a 1/4" hole in the Nissan plate and ream out an existing hole slightly. I used a round file to get the hole enlarged in about five strokes. Overall great instructions and excellent fit!"
How often do you shop at JC Whitney.com? Once a Year