PROTHANE SUSPENSION - CONTROL ARM BUSHINGS

Select Vehicle

Priced from:

$11.97 - $172.77
Product #: 15797G Brand: Prothane
Customer Rating: 4.3 of 5 stars
Features

PROTHANE – POLYURETHANE AXLE PIVOT BUSHINGS

  • Meets and exceeds OEM standards
  • Premium polyurethane compound – far superior to rubber and other materials
  • Tightens up sloppy handling and improves ride quality

Axle pivot bushings by Prothane can help tighten up sloppy handling and improve ride quality due to its solid polyurethane fabrication, which far outlasts and outperforms rubber. Prothane is a manufacturer of high performance polyurethane components that give enthusiasts a better ride, on the street or at the track.

See product for application and installation details.



Overall Rating
4.3 out of 5
4.3 out of 5
Open Ratings Snapshot
Rating breakdown 3 reviews
5 Stars
2
4 Stars
0
3 Stars
1
2 Stars
0
1 Star
0
Ease of Use/Installation
3 out of 5
Quality/Construction
4.3 out of 5
2 of 3(67%)reviewers would recommend this product to a friend.
Product ReviewsWrite a review
Overall Rating
5 out of 5
5 out of 5
Good Quality Products
December 12, 2014
Droid Zig
Location: Tucson, AZ, USA
How often do you shop at JC Whitney.com? First Time
Ease of Use/Installation
4 out of 5
4 out of 5
Quality/Construction
5 out of 5
5 out of 5
" These are so much better than the stock rubber units. The ride is a little rougher but it is so well worth it, and these will last a lot longer than the factory bushings. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
5 out of 5
5 out of 5
Big time performance gain!
June 28, 2014
Warin.Static
Location: Lafayette Township, NJ, USA
How often do you shop at JC Whitney.com? First Time
Ease of Use/Installation
3 out of 5
3 out of 5
Quality/Construction
5 out of 5
5 out of 5
" I installed these on my 05 VW GTI 1.8T /MK4. I had installed these in a matter of a few hours, considering I do not have a press or a bench mounted vice. If you have a spring compressor and two huge washers, as I did, no problem. I should have done this first. I had previously done a bunch of performance upgrades and mods and it didn't seem like they made as big of a difference as they should have. Then once I put these in it all came together. How can horsepower be use properly if the car is flexing at every old burnt out rubber bushing! Rougher ride, but I knew that going into this. Handles like an indy car now (over exaggerating a bit), little to no wheel hop and launches faster with again little to no wheel spin. "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0
Overall Rating
3 out of 5
3 out of 5
bushings were fine but the sleeves were not
June 25, 2014
roadrashgixer
Location: Denver, CO
How often do you shop at JC Whitney.com? Once a Year
Ease of Use/Installation
2 out of 5
2 out of 5
Quality/Construction
3 out of 5
3 out of 5
" The bushings fit fine. The center of the supplied sleeves are too small, by about a half mm, to fit the stock Chevy control arm bolts. I had to sand down the body of the bolts to make them fit. No fun! "
0points
0out of 0found this review helpful.
Was this helpful?helpful0unhelpful0